Custom cuts available. If you want the whole transmission case that is possible as well. Automatic starters are suggested for use with these cases as the bushing area may be enlarged. For 6V you may use automatic starter: 141911021 The 12V Automatic starter is SR17X. When I cut these I pull the next one off the pile. Bushing holes are not guaranteed which is why I suggest the automatic starter. I do not clean the core so it may be a bit dirty from previous use or sitting outside.

Cast Iron & Aluminum Bodied Distributors restored to factory finish I start by fully cleaning the distributors using a protective and corrosion inhibiting cleaner. I buy these specialty cleaners from a company my family has had a relationship with for over 30 years. They know their business. I leverage their knowledge in cleaners. Every part of the cleaned distributor is checked for wear and tear. Worn parts are replaced with new or quality used Bosch parts. I also have many NOS Bosch parts including shafts, cam lobes, base plates, etc. Some distributors can be fully rebuilt using all new parts with the exception of the housing. That is new bushings, new shaft, new base plate, new everything. I bring back the luster and quality finish of the original distributor. When rebuilding a distributor I use new Bosch parts such as fiber washers, o-ring. When Bosch parts are no longer available I have parts manufactured to specification matching original quality. I buy directly from Bosch and utilize their quality parts for a proper rebuild and restoration. Many of the later model distributors have plastic parts. These plastic parts fade and become brittle after over 40 years of being exposed to heat from the engine. My new plastic parts are soft and supple and are made from 21st century plastics that can be exposed to heat and oil. Cast iron units are fully disassembled and cleaned down to the tiniest crevice using an ultrasonic cleanser with corrosion inhibiting agents. The existing paint is chemically removed without damaging the underlying cast iron metal. A new base coat of paint is applied and tested for proper adhesion whereafter multiple coats of paint are applied. The whole unit is then baked in a furnace to chemically adhere the paint to the cast iron for the best protection. This prevents chipping and scratching. Bushings are checked to be in spec and are either replaced or unit is sleeved for new bushings. New replacement parts include new Bosch shims, washers, clips, o-ring, etc. Checked to be in spec with a multiple recently restored and calibrated Sun distributor testing machine. NOS Genuine Bosch vacuum canisters, caps, rotors, condensers, and points available. As for turn around time. You tell me when you need it and I will do what I can to meet your needs.